MS7100 vs TK100 for boards and wood fiber
On this page
Compare the sample and probe
| What to compare | MS7100 | TK100 |
|---|---|---|
| Typical sample | Timber, boards, bamboo or fiberboard | Wood fiber, grain, hay, straw or bran |
| Contact with sample | Pins enter the wood at the point of measurement | Long probes enter material that can surround them |
| What to check | Wood code, surface access and whether pin marks are acceptable | Supported material, probe access and consistent contact in the sample |
| Listed range | 0–80% | 0–80% |
| Display resolution | 0.1% | 0.1% |
Checking boards before finishing
Start with the MS7100 when you can insert pins into timber or boards. Choose the applicable wood code and compare readings taken under similar conditions. If you need to keep a finished face unmarked, a pinless surface meter such as the DM200W is another option for supported wood samples.
Checking loose wood fiber or other bulk samples
Consider the TK100 when the material can surround the probe and you can keep sampling conditions consistent. Loose fiber can vary within a batch. Compare readings from representative sample points and check the instrument settings against the material you handle. For work that mainly involves sawdust, compare the sawdust-focused TK100W as well.
What the shared range tells you
Both meters list a 0–80% measuring range and 0.1% display resolution. The reading depends on the sample, the setting and how the probes make contact. Use the measuring method required by your work when a reading will determine whether a batch is accepted.
Browse all wood moisture meters or read the moisture meter buying guide for other materials and sensor designs.